Bridging issue
Hi folks - having an issue with bridging - see the pic (in particular the grid/mesh in the front). Pretty sure it's not supposed to look like that! It's the ZeroFilter (https://github.com/zruncho3d/zerofilter) cartridge.
Any ideas or suggestions on things to try? The filament is ASA (FormFutura ApolloX).
GitHub
GitHub - zruncho3d/zerofilter: A recirculating air filter that fits...
A recirculating air filter that fits in the tightest of spaces - GitHub - zruncho3d/zerofilter: A recirculating air filter that fits in the tightest of spaces
2 Replies
intense-chocolate•2y ago
Which slicer are you using? which material, which temp? try setting the acceleration for bridges to something below 1000 and also check the print speed (try 100 or lower) and cooling on the bridges (try 1.5 of the usual rate)).
rival-blackOP•2y ago
I’m using SuperSlicer. Material is FormFutura ApolloX ASA, printing at 250 degrees. I’ll have a go at the tweaks you mentioned, thanks!