pin e_uart_pin is an alias for PC11
So, i am aware of the discussion in the past , and it DID work with the toolboard_quirks.cfg include when i put it in the last line of my user overrides.
Using an Orbiter 2.0 with an EBB36_12, i now switched from the initial "safe" profiles to the performance profiles and set the extruder settings in the overrides to the Subvalues (Hysteresis etc) to the 0.85A values, but with the 0.707 current set.
Now i am getting again the dreaded Error and i can't figure out where the heck this is defined that it overrides the toolboards included "e_uart_pin=PA15" (or whatever is causing this)
And yes, this is Mikl's dreaded RatOS 2, SKR Mini E3 V3 and EBB 36_12 combination on the Minion 🙈
I am also using custom motors on xyz, but that has nothing to with it. I just use the "standard" stepper configs atm.
1 Reply
national-goldOP•3y ago
I had to enter the line:
[tmc2209 extruder]
uart_pin: toolboard:e_uart_pin
in the overrides and it worked 👍