Dam it looks like I had a false run out detection with my Orbitor sensor. Anyone else experienced
Dam it looks like I had a false run out detection with my Orbitor sensor. Anyone else experienced similar, anyone disabled the run-out detection only feature only?
12:00 AM
echo: Set Load busy!
11:59 PM
echo: Clear Unload busy!
11:59 PM
echo: Clear Load busy!
11:59 PM
echo: Load new filament! Wait until is loaded, then resume printing.
11:59 PM
echo: Unloading filament...
11:59 PM
echo: Filament runout!
1 Reply
this is by design.
they are designed to anoy you
the orbiter sensor is just not good