V core 3.1 500
I just build and test my V500.
I don't know whether it is good or not.
Y axis recoommanded shaper and accel seems to low to me. (mzv 3400) is it normal for V500?
4 Replies
That's relatively normal yeah, but the graph looks a little weird, did you check if your belt tension is equal?
You should be able to get over 4k on Y
But depends on what you put on your toolhead
foreign-sapphireOP•2y ago
thank you for you reply. I've checked belt tention and it is equal. may I increase belt tension? my toolhead is ebb42+lgx lite+v6+chc pro.
Yeah i think so
foreign-sapphireOP•2y ago
Thank you miklschmidt! my y tention recommended accel is 4900 after adjust belt tension again. 😁