Reset debugging
Update, along with that, it compulsively connects and disconnects, when connected i can reflash it but it does not work sometimes due to it just disconnecting midway
8 Replies
Also, snap a pic of the soldering on the top of and bottom of your board, and I'll take a look at it.
Check your soldering, when this happens usually it's the reset pin making intermittent contact to ground. It might be easiest to carefully remelt the solder joints on the top and bottom of the Bit-C
ok, i will check that now
is it maybe it's the flux residue?
It wouldn't hurt to clean up that flux residue. I'd recommend carefully remelting the RST and GND pin right next to it on both sides, and then cleaning up the flux residue and seeing if it makes a difference in behavior.
i see, i will let you know how it goes in a bit, thank you
no problem. It's also worth checking the reset switch itself on the board and making sure there isn't any solder or flux residue as well, since that can also contribute to the same issue 👍
you know what, that worked, once again, thank you for the help, lets just hope it stays that way