WIf you activate the Debug grip profile, does it show the toggling data in the debug tab?
Can you try enabling the 5V SPI Clock checkbox?
Can you try enabling the 5V SPI Clock checkbox?
WI'll check up on this tomorrow
RThis?
R
Wyep
Rok did the 5v
Rraw btn shows flashing
RWHmm, you can try reverting to the last working firmware, was it b7 before?
fb-rhino_v1.0.17b7.zip624.23KB
RI'll try it If I can get Windows defender to let me download it
R
Wugh, it's a bit too trigger happy
RI don't see any options to bypass it in Edge... maybe I'll have to turn it off in windows if it'lll even let me
WTurning off realtime protection should do it
Rnot sure where to turn that off, still looking
Rok got it
Wyeah, just run flash.bat and it should upload it
Rdownloaded. Realtime protection was in settings'
R
Rinvalid dfu sig a problem?
Rguess not
WHow's the buttons?
Rdamn. Paddle still flashing. Everything else appears ok at first glance
Rgrip and extension get BT power from base and that should be it, though I'd prefer to get the grip set up as a profile in VPFC so I can delete the BT device
Wcan you try setting Grip profile to shift register board?
WAny difference?
Rno
Rflash freq maybe slower a little bit, but stil on/off
Wahh, bummer. I'll have to sign off for today
Runderstood. I appreciate your efforts. For now I'll use one of the pinky switch hat directions as the "paddle"
R@walmis any progress? Only thing new I can tell you is that it seems all RS buttons are affected, not just that paddle.
WTo rule out any additional variables - do you use some kind of extenstion ir is it tested directly?
WOther grips work fine? (if you have any)
RI believe other grips were fine but standby and I'll check. I have some Virpil grips and a Virpil extension I can check. The only extension I tried with RS was the RS Hornet one with paddle.
WThe glitches happen with a direct connection, right?
RThey happen both through the VPF software and through the BT connection on the RS grips.
Rnot getting button glitches with VFX grip
Rno issue with VPC 200mm extension either
Rleft the VPF profile as "VFX" and hooked the RS F18 grip up to the 200mm extension and get flashing buttons
Rin particular, the sensor control switch hat left. Through the VPF connection it flashes. Through the BT connection it doesn't seem to at the moment
RSo, in conclusion, RS buttons all flash under the VPF connection, but the only one that flashes under BT is the paddle.
WAnd this is the same with both states?
Rdidn't check that, standby
RI have the grip profile now as VPForce shift register
Ryes, it's the same for both states of that 5V switch
WAnd now with Generic grip 64but ?
Ryes, same with Generic grip 64
Rusing powered USB hub
WYou can try downgrading to v1.0.16 firmware https://vpforcecontrols.com/usb/rhino/#force=ffb-rhino_v1.0.16.bin
That will exclude at least any recent changes.
Otherwise I'm out of ideas
That will exclude at least any recent changes.
Otherwise I'm out of ideas
Rwas about to click download then remembered defender