[Flex Splines] Can't change from Straight back to Default

When using Flex Splines by @Andre Aquila <Aquila Industrial>, I can switch the placement of conveyor belts from "Default" to "Straight" but I can't switch it back unless I leave the server or save that I'm playing. It's not a large issue for me but it can be an inconvenience.

Additionally, when holding "R" It will only show "Straight" as an option.

If there may be a mod conflict that is causing this, here's my modlist:
(however, I don't believe any of these should be an issue for that as I haven't had any other issues besides this.)

- Infinite Zoop
- Structural Solutions
- Linear Motion
- Modular Load Balancers
- Flex Splines
- EquipmentMk2
- DI More Lights
- Cable Choices
- More Decorations
- Shorter Hard Drive Research
- Automated Artifacts
- More Swatch Slots
- Doggo Transportation
- Unlimited Dimensional Depot
- Fluid Awesome Sink
- DI Transportation
- Awesome Artifacts
- No Fall Damage 2

- Infinite Zoop
- Structural Solutions
- Linear Motion
- Modular Load Balancers
- Flex Splines
- EquipmentMk2
- DI More Lights
- Cable Choices
- More Decorations
- Shorter Hard Drive Research
- Automated Artifacts
- More Swatch Slots
- Doggo Transportation
- Unlimited Dimensional Depot
- Fluid Awesome Sink
- DI Transportation
- Awesome Artifacts
- No Fall Damage 2

Thanks!

Solution

Just release a new version, i think now it will work properly. Let me know!

Jump to solution

PenguBlueOP•11/3/24, 10:32 PM

Additional Info that I've just found: I can switch back to the "Default" mode if I use the base game belts to switch the type and then select the flex belt again. It at least means I don't have to re-log anymore to switch

PPenguBlue Additional Info that I've just found: I can switch back to the "Default" mode if...

AndreAquila•11/5/24, 5:28 PM

Good to know Pengu. Im looking into it now!

Solution

AndreAquila•11/5/24, 5:34 PM

Just release a new version, i think now it will work properly. Let me know!

AAndreAquila Just release a new version, i think now it will work properly. Let me know! 🙂

PenguBlueOP•11/5/24, 10:10 PM

This is fixed! Thank you!!