Retro - Hi all, just set up my nibble snap. I n...
Hi all, just set up my nibble snap. I noticed that when I hit the key mapped to 7 on the default layout. It activates all the other keys in that row.
6 Replies
It looks like everything is installed properly, not sure if its a firmware issue or something? Has anyone seen this issue?
I'd double check the solder on your diodes. You might be able to find documentation or otherwise trace that section back to find out which one it is, if that is the case.
I doubled checked the diodes and reflow most of it but still having the same issue.
Anyone else have any ideas
@jaygreco sorry to ping but any advice? The discord seems pretty slow lately
Hey sorry - busy day. Is the 7 the only key that has the issue? I see you built with sockets. I would check for a solder blob or smear on either of the sockets, or the diode associated with the 7 key. Typically that means there’s a short to ground somewhere between the switch and the pin on the IC, which makes the board think the whole row is pressed when it’s just one key.
Thanks for response. I eventually figured it out something was being grounded, still not sure what it was but I resoldered the sockets and diode a few times and eventually it was working