Gyro "drift" on Rog Ally (Bazzite OS) - unsuccessful calibration (never ends)
I tried to setup the gyro for Horizon zero dawn in my Rog ally with Bazzite OS installes. The gyro was set to enable when full pull LT (so I can use gyro while aiming) but it's litterally unplayable, basically it was always "drifting" down and to the right (south east I may say).
The gyro was sending a direction constantly even if the deck was sitting flat on the table. Every time I pull LT the camera was going down, felt like a joystick drift.
I did quit and reboot the game. Same issue. I tried also to recalibrate in Steam settings but the process never ends, it seems the tolerance index is not acceptable so it cannot finish the calibration process.
9 Replies
You are the first one to report this on the Ally
try to lay the device on the floor
and take a video
Here's the video when I try to calibrate
It stays forever like that, the calibration never ends
The Rog Ally lays on firm surface
Solution
looks fine, tad bit too high
swtich autocalibration on
then pull the gyro slider 40%
that will fix the calibration
Is it like that right?
yeah its done
turn off autocalibration to prevent it from messing up
I tried again and apply the Dualsense edge gyro community layout and it works like a charm
thank you very much for your help bro