A1111 Stable Diffusion 1.10.0 Pod filling up disk immediately
I added around 10GB of space to the pod after failing to boot once, and it immediately fills up to 100% with stuff like this showing up on container.
The same exact Storage Volume worked to boot the pod OK yesterday. I would like to keep all my LORAs and settings, but this is annoying to deal with.
7 Replies
Make sure you have volume storage
Which version of the template are you using? Make sure its .post7
Well yeah, but it's a bit annoying that something that worked yesterday would need way past 10GB more. Doesn't seem like everything is working correctly.
Using .post7
Works fine for me, my network storage is 100GB
It uses tar instead of rsync now to reduce the sync time for network storage
Still uses rsync in community cloud, but tar when the filesystem type is
fuse (which is usually network storage or the hosts that offer it)
The tar is also temporary just for the duration of the sync, then gets deleted and frees up your storage space afterwards
So I suggest increasing your storage by a few GB to enable the sync to completeYeah, ended up doing this, hopefully works.
Did it work?
There seems to be over 15GB more in use than yesterday, which seems completely excessive to be intended, and right now my pod is not loading. Stuck on "Port not up yet"
And "Container is READY!"...
so yeah
no.
Check the application logs
Must be something causing the application not to start up correctly