18 Replies
you need to turn it all the way up.. TelemFFB is trying to center the axis before it starts sending axis information to MSFS. If you have the spring force turned down, it can't do that
Trying now
the settings are per aircraft... so if you jumped in the 145 instead of the 160, the force trim button needs to be configured again.
The Black dial is at maximum, restarted my MSFS on runway ready for take off, my Rhino is 100% stiff and still no joystick movement in Cockpit, Red x is back
configure the force trim button (you are still in the airbus?)
trying now
WOW! The black dial works perefctly in adjsuting the joystick force feed back however still no joystick movement in Cockcpit and red x is still there
The red x should go away when you configure the button. What does the TelemFFB log say? (Log->Console Log)
I dont think my Rhino is setup correctly in the configurator tool or correctly calibrated in the configurator tool or configued in the MSFS tool
also send a pic of your effects tab in configuratior (like that screenshot)
looking now
while you are in MSFS with TelemFFB running and you pause, does the stick go limp?
yes the stick does limp
When I unpause the sim the stick automatically does resume
When I lift off with the collectived and land again the stick responds
the "centering" on your rhino looks a little off.. TelemFFB is trying to center the joystick before it starts sending data... try to manually move the joystick until the dot is fully inside the circle
However there is no movement of the stick forward backwards etc. unable to fly
Yes that blue bubble works perfectly in the configurator tool
would you like to do a team viewer?
you can send me a link to your voice channel and I can send you a link to my team viewer
You can DM me and we can set it up
Do this:
- Get set in the helicopter with TelemFFB running....
- disable the "force trim" checkbox in TelemFFB.
- Your axes should start working.
- This is not the state we want to be in, but it should tell us where the problem is.
If the axes do move:
- re-enable the 'Force Trim" checkbox in TelemFFB
- without touching the joystick, take a screenshot of the axis position in configurator just like I did right above (where it shows the center point and current position of the joystick)