Raspberry Compute Module 4 with Stereopi v2.02 and 2 cameras
Hi All!
I would like to know if any of you have ever worked with the compute module 4 using a stereopi v.02 and 2 cameras of the IMX477 model. I have been working on it for a while, but I absolutely cannot get the cameras to work on it. Initially, with the command 'vcgencmd get_camera,' I had:
supported=2 detected=1, libcamera interfaces=1
It detected one camera but not the other. However, on the stereopi, there are 2 camera ports, but I cannot get both to work simultaneously. I am desperately looking for a solution, but I can't find anything. I modified my /boot/config.txt file, switched back to the Buster version instead of Bullseye because it is not very compatible with both the stereopi and the compute module. I want to clarify that I am not working with an Arducam but with a stereopi v2.02 with 2 camera ports.
If anyone has a solution to activate both cameras on this stereopi, it would make me very happy.
Best regards.
1 Reply
It seems you're facing challenges with getting both cameras to work simultaneously on the Compute Module 4 using Stereopi v2.02. Ensure that your /boot/config.txt modifications are correctly configured for dual-camera operation. Check for any specific settings related to camera ports and configurations.
If issues persist, consider reaching out to the Stereopi community forums or support channels for more targeted assistance. Collaborating with others who have experience with this hardware combination may provide valuable insights and solutions tailored to your setup. Best of luck in resolving the camera configuration issue!